Physical:
- Width excluding hanging bracket: 130 mm (5.1 in.)
- Width including hanging bracket: 175 mm (6.9 in.)
- Height excluding hanging bracket: 134 mm (5.3 in.)
- Height including hanging bracket: 242 mm (9.5 in.)
- Horizontal fixture spacing: 150 mm (5.9 in.) (center-to-center using interlock couplers)
- Vertical fixture spacing: 150 mm (5.9 in.) (center-to-center using interlock couplers)
- Depth: 146 mm (5.7 in.)
- Weight including hanging bracket: 2.2 kg (4.85 lbs.)
- Weight excluding hanging bracket: 2.0 kg (4.41 lbs.)
Dynamic Effects:
- Beam Dimmer/Shutter: 0 – 100% continuous dimming, variable flash rate and duration, and atomic effects
- Beam Dimming options: Choice of four dimming curves
- Beam P3 Mix: Videomapping of fixture with variable crossfade between DMX control and video control
- Aura Dimmer/Shutter: 0 – 100% continuous dimming, regular and random strobe effects
- Aura Dimming options: Choice of four dimming curves
- Aura Color mixing: RGB, independently variable 0 - 100%
- Aura Color temperature control: Variable 2000 - 11,000 K
- Aura Virtual Color wheel: 36 color presets, continuous rotation & random color
- Aura PixelMapping: individual RGB control of each Aura pixel
- Aura P3 Mix: Videomapping of fixture with variable crossfade between DMX control and video control
- Built-in FX: Various pre-programmed FX on Beam, Aura and combination of both
Control And Programming:
- Control Protocols: DMX, RDM, Art-Net, RDM over Art-Net, sACN and P3
- Protocol detection: AutomaticDMX channels: 1, 3, 4, 19, 64
- Setting and addressing: RDM, RDM over Art-Net or P3
- DMX Modes: 1-channel, 3-channel, 4-channel, Basic, Extended
- Fixture Identification: User-settable ID number
- DMX compliance: USITT DMX512-A
- RDM compliance: ANSI/ESTA E1.20Art-Net Compliance: Art-Net 1, 2, 3 and 4; including RDM over Art-NetsACN Compliance: ANSI E1.31 - 2016
- Martin P3 Compliance: P3 System Controller Software 5.1.0 or newerDMX/RDM Transceiver: RS-485
- Ethernet Transceiver: 10/100Mbit
- Firmware update: via DMX using Martin Companion or via Ethernet using P3 System Controller
Control/User Interface:
- Device status: Multi-color status LED
- Device test and reset: Pushbutton to call up local test patterns and reset device
Optics And Photometric Data:
Lens Diameter: 95 mm
Front Accessory Holder: PAR30 size
Beam/Strobe LED
- LED Type: Cold White
- Max. total lumen output: 3350 lumens (boost/strobe mode)
- Max. total lumen output: 1600 lumens (continuous mode)
- Beam Angle: 11 Degrees (half peak)
- Field Angle: 22 Degrees (one-tenth peak)
- Binning: Tight color and flux binning
- Color Temperature: 5700 K
- CRI (Color Rendering Index): >80
- Resolution: 16-bit
- Minimum LED lifetime: 50,000 hours (to >70% luminous output)
Aura Backlight LEDs
- LED Type: RGB
- LED Quantity: 16
- Binning: Tight color and flux binning
- Color Temperature: Variable (2000-11,000 K)
- Resolution: 16-bit per color per pixel
- Minimum LED lifetime: 50,000 hours (to >70% luminous output)
* All Photometric Data measured in steady state (30 minutes warm-up time) at 25°C ambient.
P3 Video Processing:
- Color Resolution: 16 bit per color (48 bit per pixel) (Aura)
- Color Temperature Control: 2000-11,000 K (Aura)
- Synchronization: System-wideFrame Rate: Up to 75 frames/sec
- Brightness Control: 0-100% (maintaining full color depth)
- Color Gamut Control: full spectrum control (Aura)
- Gamma Correction and Control: fully controllable (Aura)
Construction:
- Housing: Aluminum
- Color: Black
- Protection rating: IP65
Installation:
- Mounting options: hanging from bracket, hanging from clamp attached directly to fixture or hanging from other fixture using interlock mechanismLocation: indoor or temporary outdoor use
- Clamp attachment to hanging bracket: M12Clamp attachment directly to fixture: M8
- Maximum vertical column height: 16 fixtures
- Orientation: Any
- Minimum distance to combustible materials: 0.1 m
- Minimum distance to illuminated surfaces: 0.2 m
Connections:
- AC Power, DMX and Network input: cable tail with PDE hybrid connector (IP65)
- AC Power, DMX and Network thru: chassis-mount PDE hybrid connector (IP65)
All connections hot plugging compatible
Electrical:
- AC power: 100-240 V AC nominal, 50/60 Hz
- Power supply unit: Auto-ranging electronic switch mode
- Typical half-cycle RMS inrush current at 230 V, 50 Hz: 1.1 A
- Typical earth-leakage current: 0.25 mA
- Power Factor: 0.99 @ 100 V , 0.98 @ 120 V , 0.95 @ 208 V , 0.96 @ 230 V , 0.94 @ 240 V
- Max current draw: 0.6 A @ 100 V / 120 V , 0.3 A @ 208 V / 230 V / 240 V
- Typical current draw: 0.5 A @ 100 V , 0.4 A @ 120 V , 0.2 A @ 208 V , 0.2 A @ 230 V , 0.2 A @ 240 V *
- Power Consumption
- Maximum: 55 W
- Typical: 50 W *
- Idle: 4 W *
* Measurements made at nominal voltage. Allow for a deviation of +/- 10%.
Typical: full output white.
Idle: no output.
Thermal:
- Cooling: Convection
- Maximum ambient temperature (Ta max.): 40° C
- Minimum ambient temperature (Ta min.): 0° C
- Typical heat dissipation (calculated, +/- 10%): 171 BTU/hr
Environmental:
- RoHS: Compliant
- REACH: Compliant
- WEEE: Compliant
- Proposition 65: Compliant
- Efficacy (max output): 74.4 lm/W
- LWR*: 1,523 lm/kg (691 lm/lb)
LWR = Lumen-to-Weight Ratio
Approvals:
- EU safety: EN 60598-2-17 (EN 60598-1), EN 62471, EN 62493EU EMC: EN 55015, EN 55032, EN 55103-2, EN 61000-3-2, EN 61000-3-3, EN 61547
- US safety: UL 1573US EMC: 47 CRF Chapter 15 Class B
- Canadian safety: CSA 22.2 No. 166
- Canadian EMC: ICES-003 Class B, ICES-005 Class B
- Australia/NZ: RCM
- United Kingdom: UKCA
Related Items:
- VDO Atomic Dot WRM in cardboard: P/N 90357702
- Martin P3-050™ System Controller: P/N 90721090
- Martin P3-150™ System Controller: P/N 90721015
- Martin P3-300™ System Controller: P/N 90721060
- Martin P3-PC™ System Controller: Free download from martin.com
- Martin Companion Cable (for firmware update over DMX): P/N 91616091
- Martin Companion Software (for firmware update over DMX): Free download from www.martin.com
Accessories:
Junction Boxes
- Passive Junction Box Power-DMX-Ethernet to PDE: P/N 91610001
- Active Junction Box Power-DMX-Ethernet to PDE: P/N MAR-91700002
Adapters Cables
- BreakIn Cable Power-DMX-Ethernet to PDE: P/N MAR-91700000
- BreakOut Cable PDE to Power-DMX-Ethernet: P/N MAR-91700001
- BreakInOut Cable Power-DMX to PDE: P/N MAR-91700003
Optical Accessories
- VDO Atomic Dot Diffuser 60 Degrees: P/N 91610002
- VDO Atomic Dot Diffuser 30 Degrees: P/N 91610005
Mechanical Accessories
- Super Lightweight Half Coupler Rigging Clamp, black: P/N 91602018
- G-clamp (vertical hanging installation only): P/N 91602003
- Half-coupler clamp: P/N 91602005
- Quick trigger clamp (vertical hanging installation only): P/N 91602007
- Safety Cable, SWL 60 kg, BGV C1 / DGUV 17, black: P/N 91604006
- Safety Cable, SWL 60 kg, BGV C1 / DGUV 17, silver: P/N 91604007
- Set of 10 VDO Atomic Couplers: P/N 91610003
- VDO Atomic Half Coupler: P/N 91610004
- VDO Atomic Interlock Adapter: P/N 91610006
- VDO Atomic Pivot Coupler: P/N 91610007
- VDO Atomic Dot Double Width Bracket: P/N 91616117
- VDO Atomic Spigot Adapter 28mm: P/N MAR-91616118
Pre-Assembled Hybrid PDE Cables
- Power+Data Cable Rental PDE-PDE 1m: P/N 91616001
- Power+Data Cable Rental PDE-PDE 2,5m: P/N 91616002
- Power+Data Cable Rental PDE-PDE 5m: P/N 91616003
- Power+Data Cable Rental PDE-PDE 10m: P/N 91616004
- Power+Data Cable Rental PDE-PDE 25m: P/N 91616005
Bulk Hybrid PDE Cable and Connectors
- Power+Data Connector PDE Male: P/N 91611701
- Power+Data Connector PDE Female: P/N 91611702
- Power+Data Cable Power-DMX-Ethernet Rental 100m: P/N 91616006
DemoKit
VDO Atomic Dot Demo Kit: P/N 91311001
Flightcase
- Flightcase for 15 x VDO Atomic Dot: P/N 91515053
- Flightcase Extender for 15 x VDO Atomic Dot: P/N 91515054
Ordering Information:
VDO Atomic Dot CLD in cardboard : P/N 90357701